 |
 |
| Welcome to |
| Zulgtal Lab's the originator of the "Ultra-Colloid" Mineral Supplements |
 |  |  |  |  |  |
 |  |  |  |  |  |  |
 |  |  |  |  |  |  |
| Zulgtal Lab's |
| jjjjj |
| Thank you for visiting TrueHealthFacts.com |
| Copyright © 2006-2012 TrueHealthFacts.com All rights reserved. |
All electro-colloidal processes produce both Colloidal
particles and “Ions”. Zulgtal Lab’s proprietary technology
enables a precise control over the proportion of each. This
enables the user to decidewhich formulation proportion of
ions to colloids best fits the conditions it is being used for.
Zulgtal labs is currently providing a 50 PPM Colloidal
concentrate and a 240 PPM Colloidal plus Ionic
concentrate.
Any product claiming a PPM concentration of pure
Colloidal particles (No additives, proteins, salts, etc)
exceeding 55 PPM in a mg\L measurement is likely a
FAIRY TALE. The PPM calibrated TDS conductivity
measurements for Ionic concentrations may exceed 500
PPM but exhibit little gain after 250 PPM and would begin
to have unnatural negative influences on the body over 1000
PPM.
Colloidal or Ionic?
A. Higher Colloidal Ratio products seem to have more
“Staying power”.
B. Higher Ionic Ratio products seem to be more topically
effective and faster acting.
C. Both products if taken internally are pre-absorption
enhanced by pre-absorption by “swishing in the mouth”
for a few moments.
D. Ionic products have less agglomeration problems
(Sediment) and less light sensitive.
E. A colloid with good concentration will have a strong
metallic silver taste. Excessive ionic concentrations begin
tasting aciding.
FOR FURTHER INFO SEE THE PAGE HEADING:
“ZULGTAL LABS PRODUCT QUALITY TESTING”
AND “ABOUT COLLOIDS”
particles and “Ions”. Zulgtal Lab’s proprietary technology
enables a precise control over the proportion of each. This
enables the user to decidewhich formulation proportion of
ions to colloids best fits the conditions it is being used for.
Zulgtal labs is currently providing a 50 PPM Colloidal
concentrate and a 240 PPM Colloidal plus Ionic
concentrate.
Any product claiming a PPM concentration of pure
Colloidal particles (No additives, proteins, salts, etc)
exceeding 55 PPM in a mg\L measurement is likely a
FAIRY TALE. The PPM calibrated TDS conductivity
measurements for Ionic concentrations may exceed 500
PPM but exhibit little gain after 250 PPM and would begin
to have unnatural negative influences on the body over 1000
PPM.
Colloidal or Ionic?
A. Higher Colloidal Ratio products seem to have more
“Staying power”.
B. Higher Ionic Ratio products seem to be more topically
effective and faster acting.
C. Both products if taken internally are pre-absorption
enhanced by pre-absorption by “swishing in the mouth”
for a few moments.
D. Ionic products have less agglomeration problems
(Sediment) and less light sensitive.
E. A colloid with good concentration will have a strong
metallic silver taste. Excessive ionic concentrations begin
tasting aciding.
FOR FURTHER INFO SEE THE PAGE HEADING:
“ZULGTAL LABS PRODUCT QUALITY TESTING”
AND “ABOUT COLLOIDS”
Colloidal vs. Ionic – Mineral Debate Summary.
| Ultra Colloidal Minerals |
